Is Technology Always Advancing?
Folks, Technology: Always Advancing? I believe most of us think of technology as always advancing. A quick look at the evolution of mobile p...
Folks, Technology: Always Advancing? I believe most of us think of technology as always advancing. A quick look at the evolution of mobile p...
Folks, Before the mid 2000s, electronics manufacturers had to be concerned with the challenges of innovation at a low cost. Failure to meet the...
Folks, Patty had been working with engineering on a new product that needed a very precise and controlled volume of the stencil printed “brick&...
Folks, Let’s assume you are trying to improve the productivity of your SMT assembly lines. You work at a facility that manufactures high v...
Folks, The conclusion of the Bob and Fred break saga…... Phil stared, “The uptime on AXI’s four SMT production lines is…...
(continued from previous post) “Fred break, Bob break?” Phil asked. Folks, The “Fred and Bob Breaks“ saga continues, &ldq...
Folks, Dr. Phil James, a former student of “The Professor”, gets a phone call, let’s listen in…... Phil James was staring out...
Folks, My interest was piqued by a recent article from the pen of good friend, Ray Rasmussen. In this a href="http://www.pcbdesign007.com/pa...
Folks, A compilation of my blog posts, titled, The Adventures Of Patty And The Professor, is now available in soft and hard copies. The advantage...
Folks, I was at SMTAI (Surface Mount Technology Association International) from September 24 and 27, 2010. As I mentioned, I cha...
Folks, I will be at SMTAI (Surface Mount Technology Association International) September 26 and 27, 2010. I chair a session on A...
Folks, the adventures of Patty and friends continue…... Patty was just wrapping up a few things before lunch. Her company, ACME, had...