Solder Coating Thickness for Tabbing Ribbon
While it is important to have at least 10µm of solder on each side of a tabbing ribbon to form a proper solder joint during cell interconnection...
While it is important to have at least 10µm of solder on each side of a tabbing ribbon to form a proper solder joint during cell interconnection...
It is not often that we get a request for SIR (Surface Insulation Resistance) and/or ECM (Electro-Chemical Migration) results for a water washable/sol...
A few months back, while discussing tricks for hand soldering c-Si solar cells, I mentioned flux . One tip I didn’t mention is how to APPLY......
Indalloy Flux #2 is not the only option for soldering to Nitinol. There is also Indalloy Flux #3. Both fluxes are strong enough to clean the......
I was recently asked to gather some data comparing Indium Corporation’s tabbing fluxes and our largest competitor’s leading tabbing fluxes...
Maria Durham, Indium’s new Technical Specialist in Semiconductor and Advanced Assembly Materials, has been doing some research on indium lead (I...
Folks, Let’s look in on Patty and Pete and see how they are handling Rex “The Torrent.” Patty wanted to give Pete a little more ...
a href="http://blogs.indium.com/blog/eric-bastow" target="blank”>img alt="Soldering to Nitinol with Flux 2" src=&quo...
Folks, Let’s look in on Patty and her colleagues…... Sam Watkins, ACME New Hampshire site GM, had just finished meeting with his boss, A...
Readers have asked how to visually assess a tabbing ribbon interconnection after a bond test. This image is a cell that has been bond tested after sol...
With regard to soldering or wetting (coating) with indium, we are often asked to comment on the oxide formation of indium and how to remove it.......
We are often asked if it is possible to solder to stainless steel and, if so, what is the best procedure. As you may already know, stainless stee...