If you are new to Package-on-Package solder paste, expect the material to be lower viscosity then you are used to for printing or even dispensing applications. The PoP dipping process demands maximum solder transfer, which is provided by a different rheology than stencil printing paste. Pictured here is a new Package-on-Package solder paste. You can actually pour it out of the jar into a flux reservoir!
This weblog is licensed under a Creative Commons License:
The opinions expressed here are the personal opinions of Jim Hisert. Content published here is not read or approved by the Indium Corporation and does not necessarily represent the views and opinions of the company. In addition, they are not guaranteed to be correct, complete, or up-to-date. By using this blog site you understand that any information or advice is of a general nature and may not apply to your specific situation. It is the reader’s responsibility to confirm and verify all information prior to implementing any endeavors based on the information. This blog/website should not be used as a substitute for competent personal advice from a trusted professional.
