Papers by Paul A. Jaeger
by Paul A. Jaeger, Dr. Ning-Cheng Lee
As one of the major approaches to address the CFC issue, no-clean solder paste has received rapidly increasing attention. Although currently the industry seems to accept full residue paste as a temporary solution, the low residue no-clean paste technology using inert or reactive atmosphere advances immensely to meet the challenge. Presently consensus has not been established yet regarding how low a residue level could be achieved and how inert the atmospheres needs to be. In this study, a semi-empirical model is proposed to predict the soldering performance of low residue solder pastes under various levels of inert reflow atmosphere. The model predicts that the soldering performance would improve rapidly then gradually level off with decreasing oxygen content. The soldering performance vs oxygen content curves are superimposable, with the lower residue one leveling off at lower oxygen level. In general, the experimental data match this model fairly well. However, the data also indicate that, although inert atmosphere improves soldering performance, the optimum condition for bond strength performance seems to demand the presence of some oxygen. This unexpected behavior suggests that a very tight low oxygen level control may not be required. The mechanism responsible for this phenomenon can be attributed to oxidation-induced resin crosslinking. This slows down the flux drying rate as well as hinders the permeation of oxygen through the flux layer.
lead-free, pb-free, nitrogen, flux, reflow, soldering, low-residue, no-clean, solder paste, solder
[Permanent Link to this Paper ]
Posted on 1 Jan 2009
by Dr. Ning-Cheng Lee , Paul A. Jaeger, Manchao Xiao
The probe-testability of no-clean solder paste flux residue at in-circuit-test is determined mainly by the residue amount, residue location, and residue hardness. The testability increases with decreasing amount of residue, decreasing amount of top-side flux spread, and increasing amount of bottom-side flux spread. The residue amount, top-side flux spread, and bottom-side flux spread affect primarily pad probing, pad probing, and pin-tip probing, respectively. Inert reflow atmosphere helps probe penetration. Higher metal load effectively reduces the flux spreading. Among all, the soft residue approach appears to be most promising in providing successful probe contact.
lead-free, pb-free, no-clean, flux residue, solder paste, testability, probe
[Permanent Link to this Paper ]
Posted on 1 Jan 2009
by Dr. Ning-Cheng Lee , Paul A. Jaeger, Wanda B. Hance
Solder beading is a special phenomenon of solder balling when using solder paste in certain SMT applications. In brief, solder beads are large solder balls near components with very low stand-off (see scheme below). With more attention being drawn to no-clean paste applications due to CFC concerns, a better understanding of this event becomes indispensable. In this study, the data indicate solder beading was caused by flux outgassing which overrode the paste cohesive force during the preheat stage. The outgassing promoted the formation of isolated paste aggregates underneath the low clearance components. At reflow, the isolated paste melted and , once emerged from the underside of the components, coalesced into solder beads. Processingwise, this problem can be remedied by slowing down outgassing via a milder preheat profile, or by reducing print thickness. Materialwise, solder beading can be corrected by enhancing the paste cohesive force via cold welding of solder powders during the preheat stage. This in-turn can be accomplished through the use of lower activation temperature flux, coarser solder powder, higher metal load, and solder powders with lower oxide content. Other parameters which could affect the performance will also be discussed.
lead-free, pb-free, solder balling, SMT, flux, solder paste, beading, solder beading
[Permanent Link to this Paper ]
Posted on 1 Jan 2009
