by Dr. Ning-Cheng Lee
Reflow soldering of solder paste is the primary interconnection method used in SMT assembly process. The major issues which plague the reflow soldering performance include, but not limited to, bottom-side-component-holding, bridging, dewetting, low-residue, opening, solder balling, solder beading, solder-fillet-lifting, tombstoning, defective balling for BGA, and voiding. The mechanisms, causes, and cures for each issue are briefly discussed in this article.
lead-free, soldering, solder paste, SMT, bridging, dewetting, opening, solder balling, solder beading, solder-fillet-lifting, tombstoning, balling for BGA, voiding, pb-free, reflow
[Permanent Link to this Paper ]
Posted on 1 Jan 2009
by Dr. Ning-Cheng Lee , Gregory Evans
This paper focuses on many of the problems facing process engineers today. The experiments used in this study were designed to find the true causes of the problems and headaches which plague SMT assembly today. Data indicate that wicking is caused by a relative hotter component and is aggravated by non-coplanarity. It can be reduced by slower heating rate or more bottom-side heating. Bridging is caused by slumping, and is aggravated by smaller pitch dimension and slower flux wetting speed. Tombstoning is a result of uneven heating. It can be reduced by optimizing pads spacing and by using fluxes with slower wetting speed, or by a smaller print thickness. Problems such as slumping, clogging, solder balls, and white residue are also discussed.
lead-free, pb-free, white residue, solder balling, tombstoning, bridging, wicking, clogging, slumping, SMT, solder paste
[Permanent Link to this Paper ]
Posted on 1 Jan 2009
