Have You Been Keeping up with The Adventures of Maggie Benson?
Folks, Two of the workers at Ivy-Benson electronics just got engaged and they are on their way to a factory in Mexico to see if their boss Maggie Bens...
PCB Assembly
Minimizing Tombstoning
Folks, This post is an excerpt from Indium Corporation's The Printed Circuits Assemblers Guide to Solder Defects. Introduction: Printed...
Workshop at SMTAI: Defeating Defects
Folks, I am presenting a workshop on Defeating Defects at SMTAI on October 31. This workshop is based on the recently published booklet The Printed Ci...
Best Practices for Attaching Thermocouples to a PCB for Reflow Profiling: Part III
Previously in this blog series, we discussed some of the best practices for attaching thermocouples to a printed circuit board (PCB) for reflow p...
Best Practices for Attaching Thermocouples to a PCB for Reflow Profiling Part II
As discussed in the previous blog of this series, it is important to remember the best practices for attaching thermocouples to a PCB to acc...
Best Practices for Attaching Thermocouples to a PCB for Reflow Profiling: Part I
In order to get an accurate reflow profile of a Printed Circuit Board (PCB), it is important to keep in mind the best practices for attaching thermoco...
Wave Flux and Reliability
Brook Sandy-Smith, Technical Support Engineer for PCB Assembly Materials, and Phil Zarrow discuss the use of pallets when wave soldering and its impac...
Join Indium Corporation® at SMTA Empire 2017
SMTA Empire's Expo and Tech Forum on June 15, 2017, in Syracuse, New York. ...