"Per Homogeneous Material" Also Applies to Medical Devices Under RoHS
Folks, It’s been awhile, let’s see what Patty is up to… Patty was in her office, finishing lunch and reading Golf Digest. She...
Folks, It’s been awhile, let’s see what Patty is up to… Patty was in her office, finishing lunch and reading Golf Digest. She...
Here is a straightforward demonstration of NanoFoil® activation. NanoFoil is a heat source that is used to bond / solder electronics compone...
In an interview with Seth Homer (our Asst. Product Manager for Engineered Solders and NanoFoil®), we discuss how an interested customer can partne...
It’s been a while since I have mentioned equipment on this blog, so I began by searching for updates to equipment I already know and enjoy. It...
As bus ribbon makes its way around the corners of a solar panel, it must divert current at right angles. These 90° ribbons are produced from a sin...
As I mentioned in an earlier post, some soldering applications require a fluxless process. In this line of work you see an assortment of odd soldering...
We have all seen the action movies where the hero drops in at the last minute to save the day against insurmountable odds. NanoFoil® is like...
We have observed that the temperature at which two materials are bonded will set the base temperature that any subsequent CTE is measured from. T...
Wafer bumping processes have evolved in the last 10 years. The semiconductor assembly industry has gone from bumping processes using solder paste prin...
Folks, We tend to think of mixing as something that can completely even out those things being mixed. As an example, let’s assume you are ...
A traditionally bonded sputtering target experiences a wide range of temperatures over its life cycle. It is bonded at over 200°C – usually ...
Why do we care so much about target bonding? This is important because a sputtering target that truly performs will allow greater process flexibility,...