Posted On: October 12th, 2016 | By: Indium Corporation®

The Versatile Solder Preform (VIDEO)

A preform is a piece of solder (available in a wide variety of shapes)....

Posted On: March 18th, 2016 | By: Tim Jensen

Reducing Voiding in Bottom-Terminated Components Using Solder Fortification® Preforms

Watch as I discuss the challenge of voiding in bottom-terminated components - and how to Avoid the Void®....

Posted On: January 6th, 2016 | By: Indium Corporation®

Indium Corporation...We Are Everywhere!

Trade shows remain a key vehicle to showcase our products and meet with our customers to discuss challenges and opportunities. You can use them ...

Posted On: December 3rd, 2015 | By: Indium Corporation®

Design Solutions for Engineered Solders

This video is for people considering engineered solder fabrications. It discusses how to specify a solder alloy, solder preform tooling considerations...

Posted On: December 3rd, 2015 | By: Phil Zarrow

Design Solutions for Engineered Solders

This video is for people considering engineered solder fabrications. It discusses how to specify a solder alloy, solder preform tooling considerations...

Posted On: October 4th, 2015 | By: Phil Zarrow

Flux-Coated Solder Preforms

Flux-coated preforms allow you to reduce the amount of flux that’s presented to the joint and increase the solder volume. SMT expert Phil ...

Posted On: October 3rd, 2015 | By: Phil Zarrow & Indium Corporation®

Using and Specifying Solder Preforms

Why use solder preforms? SMT industry expert Phil Zarrrow finds out from Jim Hisert, Indium Corporation Manufacturing Engineer. ...

Posted On: September 2nd, 2015 | By: Phil Zarrow

What is a preform?

Phil Zarrow: Derrick, solder preforms. What are they? Derrick Herron: Well, a solder preform is a defined shape and size of a solder alloy. It can be ...

Posted On: September 2nd, 2015 | By: Phil Zarrow

Voiding in the Thermal Ground Pad of BTC Components

Phil Zarrow interviewed Derrick Herron, a technical support at The Indium Corporation. PZ: With the advent of bottom-terminating components, one of...

Posted On: August 27th, 2015 | By: Adam Murling

SMTA International 2015, One Month Away!!!

SMTA International 2015 is just around the corner. If you want to see what our engineers will be presenting at the show check out this blog; there is ...